book collections email follower instructable user

Step 13: SANDING

Picture of SANDING
sand stick.jpg
sanding 2.jpg

Ok, if you're at this step, GREAT! All of the match and measuring is done for. However, if you've not been very careful with your measurements and cuts, then this step will take you a while.

1. Using the method of your choice, sand everything flush and flat, inside and out.

2. I found a piece of scrap wood with a sanding belt stretched over it is ideal for the hard to reach angles.

3. I chose to round over all of the outside angles and corners. Its not necessary, but it could save you from some injuries.

4. Knock down any sharp corners or edges, even in you're not gonna round them over.

- DO NOT KNOCK DOWN OR ROUND OVER THE CORNERS OF THE LEG SLOTS!