book collections email follower instructable user

Storage Boxes Made Out of Cardboard and 3D Printed Parts (Update 2019-08-05)

Featured

Step 5: Mounting

Mounting

After all the parts from the printer were done and all cardboard parts were cut, I started assembling. The cardboard parts have to be glued to the 3D parts. This increases stability significantly. I use UHU Hart for that.

I started with some basic preparation:

I glued four CBoxBottomMid parts in the middle of the four cardboard side panels

Glued four CBoxBottomCorner parts to the two long cardboard side panels

Glued one CBoxBottomCenter part in the middle of the one cardboard bottom

After this was finished and the drying time was over I moved on:

Glued a short cardboard side panel to the two long side panels

Glued two CBoxTopCorner parts to the corners of the long/short side (Not all four CBoxTopCorner parts at once)

Glued the cardboard bottom

Glued two CBoxTopCorner parts to the corners of the long/short side

Finished!

In the same way I created the other 5 boxes.